View Single Post
  #3  
Old 08-19-2011, 10:04 PM
Scarab23's Avatar
Scarab23 Scarab23 is offline
Senior Member
 
Join Date: Aug 2011
Posts: 184
Default

To get power to the second horn, locate your second stock horn. it should be located on the passenger side down by the windshield wiper fluid tank. remove the stock horn and pull the power wire off the terminal. the power wire to the second stock horn runs inside a black housing along with other wires that go in that direction. The black housing that it runs in has a slit that runs the length of the wire that you can pull the inside wires out of. You will have to cut the zip-ties that hold this black housing to the crash beam and then pull the power wire back until it has enough room to reach the second hella horn's positive terminal. Should look something like this:


Connect this to the positive of the second hella. Re zip-tie the black wire housing down to the crash beam for a clean install. Now both your horns are operational and ready to go!…………… Or are they??

Theres one last modification left to make this work!

The plastic weather shield thing you take out of your engine bay when removing the bumper has a section that sticks down and when you try to slide it back into place, the second Hella-Horn you mounted gets in its way. This section:


Easy Fix:

Use a Dremmel or any other cutting tool to cut a little section away to give clearance to the second hella-horn.

Snug as a bug:

Last edited by Scarab23; 08-19-2011 at 10:11 PM.
Reply With Quote