View Single Post
  #2  
Old 10-09-2012, 05:49 PM
Markspd6's Avatar
Markspd6 Markspd6 is offline
Regional Moderator
 
Join Date: Aug 2011
Location: CYPRESS,CA
Posts: 1,067
Default

ok, just the super quick how to, skipping some of the obvious details. you cannot just swap your RA seats for Recaro seats Without setting off your airbag lights.. so, to shut the CEL off basically you will be combining your original seat computer AND seat weight sensors(lower bracket) with your new recaro seat and slider(upper bracket).

apparently theyre(the seat comp and sensors) are mated at the Mfgr... and supposedly the dealer cant just reprogram them(no confirmation on this)

step one: unplug battery(10or12mm) I prefer pulling the top part over battery post part.

step two: unbolt Passenger seat(14mm) lean back onto rear seat.

step three: unplug airbag, seat sensors, Passenger seat only!

step four: On Both Seats, (RA and new Evo) you will seperate the bracket from the slider, its four nuts each side front and back(12MM) you will be keeping your original lower bracket and using the new upper bracket(slider) from the new Recaro youre installing. pretty much thats it...

to reinstall reverse the basic steps, then plug the battery back in..

i tried just swapping the smaller computer brain by itself, but that did Not reset my CEL.. i also tried swapping the seat base entirely(using Torx bits) and theres a few compatibility issues, so you can skip both those... any questions let me know, and ill try for more pix, but really its a fairly basic operation, most any member should be able to do.. just hadnt seen it posted..
Reply With Quote