View Single Post
  #450  
Old 01-26-2017, 12:27 PM
HENRYBEAST's Avatar
HENRYBEAST HENRYBEAST is offline
Member
 
Join Date: Oct 2012
Posts: 82
Default

Quote:
Originally Posted by Jackal View Post
Job now completed and ready to lower car back down and take a test drive through some deep water.

Hey Jack, hope all is well. We haven't heard from you in a while after the tranny gave out for the second time. I was reaching out to you because my under tray finally disintegrated, and I am looking to make my own. I have the general idea of measurements and what hardware i'll be using, my concern is the mounting points, to be more specific the mounting points located closet to the engine, away from the bumper. Did you bolted it up to the chassis? if so did you drill any holes or made small mods? and if it is mounted to the chassis did you use any type of spacers in between?
Reply With Quote